NOTE: Some Engine Blocks may
need to be drilled to mount the
power steering bracket. The bracket
can be used as a template for
marking the holes. Use a 3/8-16” tap and drill holes 11/16” deep.
MAKE SURE THIS KIT FITS YOUR APPLICATION BEFORE PAINTING OR PLATING. PARTS THAT HAVE BEEN
PAINTED, PLATED OR MODIFIED MAY NOT BE RETURNED.
1. This bracket is designed to be used with the non-metric Chevrolet pumps with attached reservoir. Most pre ‘69 V-8
pumps have a single groove pulley attached with a nut, while the later V-8 pumps can have either a single or a double
groove pressed on pulley. Either style may be used. Most short water pump applications use a crankshaft power steering
pulley that bolts over the existing pulley. This should align with the power steering pump pulley.
2. Loosely attach the lower bracket to the lower threaded stud protruding from the power steering pump and the engine as
shown.
3. There are two possible ways to mount the lower bracket depending on your needs. There is a lower position and a
higher position. The difference is the location of the hole that attaches to the pump in relation to those that mount to the
engine. To assemble the kit in the lower position, simply flip the lower mounting plates over.
4. Loosely attach the adjusting arm bracket to the pump and the engine. Use 1/8” washer between the spacer and the
water pump on the adjustment bracket.
5. Verify the fit of your belts with the bracket positions and then tighten all the bolts and adjust the belt tension as normal.
INSTRUCTIONS
POWER STEERING PUMP BRACKET KIT
(Part #PS808)
